Don't get stuck redoing your floor every few years. We'll test your Newcastle slab, prep it right and install a Certified Penntek polyurea floor that bonds with your concrete, so you can stop worrying about the garage and start enjoying it.
Cascade Concrete Coatings, a Certified Penntek Dealer based in Woodinville, installs epoxy-style garage floor coatings in Newcastle using Penntek polyurea rather than epoxy. Our nearest finished floors are just north in Bellevue and east in Issaquah. Every Newcastle slab gets moisture and hardness testing at a free in-home quote, and a typical garage is coated in one day. Call 425-226-6085.
Much of Newcastle climbs the slopes between Lake Washington and Cougar Mountain. Plenty of garages here are tucked right into the grade, with the uphill side of the slab pressed against soil that stays wet from October to May. Groundwater does not stop at the foundation. It moves up through the concrete as vapor.
That vapor is the quiet reason so many garage coatings bubble and peel. A thin film that only grips the surface has nothing holding it down when moisture pushes from below. Add the hairline cracks that show up as newer slabs shrink, and the floor starts letting go at the edges first.
On top of that you have the everyday stuff. Oil drips, tire marks and grit from the drive up Coal Creek Parkway. A bare slab drinks all of it in, and the stains you scrub every spring only sink deeper. Sealers from the big box store wear off the driveway end within a season or two.
Every Newcastle job starts with a moisture and hardness test, then industrial diamond grinding, crack repair with Penntek Mender and a pure polyurea basecoat with a FadeLock UV topcoat. That's how we deliver up to 5x the lifespan of typical epoxy, a 30 to 40 year floor, with a limited lifetime warranty backed by Penntek.
Drag the handle to compare. Every pair is a real floor our team ground, repaired and coated.
The coating is only half of it. Watch the same slab go through what a Newcastle garage puts it through, once with typical epoxy or cheap poly and once the way we install Penntek.
Your slab’s age, composition and moisture all matter. We test it first, then choose the Penntek system that fits, adding a moisture barrier when the readings call for it.
Moisture & hardness testedSide-by-side tests on the same slab, in the same conditions. Typical epoxy and cheap poly on one side, certified Penntek on the other.
A floor that fails doesn't just look bad. It means emptying the garage, grinding off the old coating and paying all over again.
For a lot of Newcastle families it's the gym, the workshop, the mudroom and the first thing you see when you get home. You've put real money into it. You deserve a floor you never have to think about again, installed by people who treat your home like their own.
Nicole and Sheldon, owners of Cascade Concrete CoatingsHere's what a Certified Penntek floor from our team gives you, long after install day.
Every certified Penntek floor is built in four layers, each doing its own job. Watch it go down layer by layer, then tap a layer to see what it does for your floor.
When moisture readings call for it, we add a two-layer moisture barrier system before the basecoat.
Most people searching from Newcastle type in epoxy garage floor or concrete coatings, and that is how we would search too. What we install goes down the way an epoxy job does, so we often call it an epoxy poly garage floor. The material is Certified Penntek polyurea, and four things together make it a different floor.
For a slab with groundwater on the uphill side, the bond and the moisture plan matter most. When a reading runs high, a two-layer moisture barrier system goes down first. See the bond test in the side-by-side demo of epoxy and Penntek, and read whether moisture in concrete can ruin a garage floor coating.
Anyone can buy a kit and call themselves a garage floor company. Penntek doesn't sell to just anyone. Our team was vetted, trained hands-on through Penntek Academy and is backed by Penntek's full-time technical support team from prep to finish. That's the Penntek Standard, on every floor we install.

Garages are most of what we do in Newcastle, but the same Penntek system protects patios, pool decks, basements and commercial floors.
We keep it to three steps. You only clear the garage once, and most Newcastle garages are done in a single day.
The first visit is the one that matters most. On a sloped lot we want to see where water runs when it rains, how the driveway meets the door and whether the slab steps down anywhere. That walk-around shapes the whole plan, from how the grinder is set up to whether a moisture barrier goes in.
Here is the honest part. We have not finished a floor inside Newcastle city limits yet. Our closest garages are just over the line in Bellevue and a few minutes east in Issaquah, and every project below is labeled with its real town.
Cascade Concrete Coatings is a Certified Penntek Dealer based in Woodinville, about 15 miles away. What we bring to your hillside garage is the same process we use everywhere. A moisture meter on several spots, a scratch test for hardness, and a look at slope, drainage and cracks before we write a number down. On a hillside lot, the uphill edge of the slab often tells a different story than the door.
If you want to know what that certification means, read what a Penntek certified dealer is and why it matters.
You're probably a great fit if any of these sound familiar.
Your neighbors just north have leaned toward light, bright floors. Mount Everest was chosen in two of the projects on this page, because white and light grey flake makes a garage tucked into a hillside feel open.
If your garage sees muddy boots from Cougar Mountain trails or tracks from a steep driveway, a deeper blend like Silver Creek or Smoke stays clean looking longer. Browse every blend in our colors and styles collection.
None of these are in Newcastle. They are the neighbors. Three are in Bellevue, including two projects in the 98006 area right next door, and two are in Issaquah. The moisture readings on these slabs ran from 3.2% to 4.7%, and every one was tested before we quoted.
Look for the details that match your garage. Steps up to the house, cabinets on legs, a wood expansion strip, a cold install day. When we finish our first Newcastle floor, it goes at the top of this list. Until then, the full Cascade project gallery has plenty more.
An owner comes out, tests your slab, brings real color samples and writes a clear quote. No pressure, just a plan for a floor you'll only buy once.
We cover all of Newcastle. Homes around Lake Boren, the Olympus and Hazelwood areas, the China Creek neighborhoods, the streets off Coal Creek Parkway and the houses up near the golf course on Cougar Mountain. Most garages we see in this part of the Eastside are attached two and three car spaces with steps to the house, and many sit at the bottom of a sloped driveway.
The town's coal mining past is a fun read in the Newcastle history on Wikipedia, and the City of Newcastle website handles permits for anything else you are planning.
Your neighbors in Bellevue, Renton, Issaquah and Mercer Island get the same certified floor and the same free in-home quote.
A low-bid coating on a hillside slab is a gamble. Skip the grind, skip the moisture test, roll it thin, and the vapor coming up from below starts pushing it off within a few years. Then you are emptying the garage again, grinding the failed layer away and buying a second floor. Ask the right questions before you hire. Our list of questions to ask a garage floor coating contractor is a good start.
Get it right once and the garage stops being a project. Oil wipes up off a non-porous topcoat. Wet tires leave water you can squeegee out. Penntek calls it the longest-lifespan concrete coating with the lowest lifetime cost of ownership, and on a damp hillside lot that matters.
Don't see yours? Call 425-226-6085 and an owner will answer it.
Yes. We install epoxy poly garage floors across Newcastle using Certified Penntek polyurea instead of epoxy. It looks like a premium flake floor and offers up to 5x the lifespan of typical epoxy. See all our services or book a free in-home quote.
We do. The same Penntek system that protects garages works on outdoor concrete around Newcastle, with a slip-resistant finish and FadeLock UV stability. See patio and walkway projects.
Yes. We coat shops, showrooms, clinics and service bays in and around Newcastle. See our commercial projects.
Call 425-226-6085 or request a free in-home quote. An owner visits, tests your slab and brings color samples. We don't quote over the phone because every slab is different.
We wrote this page so people in Newcastle searching for epoxy garage floors or concrete coatings would find a real Certified Penntek crew that works their side of the lake. We would rather tell you up front that our first Newcastle floor is still ahead of us than pretend otherwise. Thanks for being here.
If your slab could be that first one, set up your free in-home quote.
Book a free in-home quote and we will test your slab for moisture and hardness before we talk colors. Call 425-226-6085.