Don't get stuck redoing your floor every few years. We'll test your Mukilteo slab, prep it right and install a Certified Penntek polyurea floor that bonds with your concrete, so you can stop worrying about the garage and start enjoying it.
Cascade Concrete Coatings, a Certified Penntek Dealer based in Woodinville, installs epoxy-style garage floor coatings in Mukilteo. The crew meters moisture, scratch tests hardness, diamond grinds and repairs cracks, then installs a pure polyurea basecoat, flake and polyaspartic topcoat. A 664 square foot Mukilteo garage was finished in September 2026, with more floors in Everett and across the water in Langley, all under a limited lifetime warranty from Penntek.
Mukilteo climbs from the waterfront by the lighthouse up onto the plateau, and plenty of homes sit on sloped lots. That often puts the garage partly into the hill, with concrete against soil on one or two sides. Marine air off Possession Sound and tall evergreens keep things cool and slow to dry.
The result shows up on a moisture meter. On the one Mukilteo garage we have finished, readings at the July consult ranged from 4.2% to 6.0%, and the highest sat right by the door. By install day in late September it read 6.2%. Same slab, different season.
That is the setup where a thin coating blisters. Moisture pushes up, a rigid film cannot breathe or flex, and it lets go in patches. Rust streaks, old stains and tire marks only make the bare floor look worse in the meantime.
Every Mukilteo job starts with a moisture and hardness test, then industrial diamond grinding, crack repair with Penntek Mender and a pure polyurea basecoat with a FadeLock UV topcoat. That's how we deliver up to 5x the lifespan of typical epoxy, a 30 to 40 year floor, with a limited lifetime warranty backed by Penntek.
Drag the handle to compare. Every pair is a real floor our team ground, repaired and coated.
The coating is only half of it. Watch the same slab go through what a Mukilteo garage puts it through, once with typical epoxy or cheap poly and once the way we install Penntek.
Your slab’s age, composition and moisture all matter. We test it first, then choose the Penntek system that fits, adding a moisture barrier when the readings call for it.
Moisture & hardness testedSide-by-side tests on the same slab, in the same conditions. Typical epoxy and cheap poly on one side, certified Penntek on the other.
A floor that fails doesn't just look bad. It means emptying the garage, grinding off the old coating and paying all over again.
For a lot of Mukilteo families it's the gym, the workshop, the mudroom and the first thing you see when you get home. You've put real money into it. You deserve a floor you never have to think about again, installed by people who treat your home like their own.
Nicole and Sheldon, owners of Cascade Concrete CoatingsHere's what a Certified Penntek floor from our team gives you, long after install day.
Every certified Penntek floor is built in four layers, each doing its own job. Watch it go down layer by layer, then tap a layer to see what it does for your floor.
When moisture readings call for it, we add a two-layer moisture barrier system before the basecoat.
Standard epoxy is stiff and holds on with a mechanical grip, which is why so many homeowners now ask for an epoxy polyurea floor instead. On a slab that breathes moisture, it blisters. In sun through an open door, it ambers. Hot tires can lift it right off the concrete.
Penntek is a combination of four things, and you get all of them together:
When readings run high, the plan can include Penntek's two-layer moisture barrier system. The goal is a 30 to 40 year floor, up to 5x the lifespan of typical epoxy. Watch it tested on the Penntek demo page.
Anyone can buy a kit and call themselves a garage floor company. Penntek doesn't sell to just anyone. Our team was vetted, trained hands-on through Penntek Academy and is backed by Penntek's full-time technical support team from prep to finish. That's the Penntek Standard, on every floor we install.

Garages are most of what we do in Mukilteo, but the same Penntek system protects patios, pool decks, basements and commercial floors.
We come to you, test, quote and then install, usually in one day. The installation process page walks through each step.
We are Cascade Concrete Coatings, a Certified Penntek Dealer based in Woodinville. Our owners handle every consult and every install, and the first thing out of the truck at your house is a moisture meter.
We test in more than one spot because hillside slabs vary from front to back. We scratch test hardness so we know how hard to grind. And we test again on install day, because a Mukilteo garage in September is not the same slab it was in July. Our post on why moisture testing matters here goes deeper.
If you started out searching for an epoxy poly floor, that is fine. The look and the steps are similar. What we install is Certified Penntek polyurea, and the material under the flake is where the difference lives.
You're probably a great fit if any of these sound familiar.
Around Mukilteo and north into Everett and Marysville, Smoke is the color people pick most, on three jobs. The Mukilteo garage went with Tidal Wave in quarter-inch flake. Two working shops chose solid Light Grey and Dark Grey instead of flake.
Your light matters more than our photos. A garage tucked under the house may want a brighter flake, while a big bay with glass doors can carry a darker one. We bring samples to your floor, and you can preview the whole lineup on our colors page.
Our work here starts with one big garage on the hill. Then it follows the same route many of you take: across on the ferry to Whidbey, where we coated a large new shop in Langley, and north into Everett and Marysville, where garages and service shops show what the floor can handle.
Each project lists real moisture readings and real install details, so you can compare them to your own garage. Everything else we have done is on the full project portfolio.
An owner comes out, tests your slab, brings real color samples and writes a clear quote. No pressure, just a plan for a floor you'll only buy once.
Mukilteo packs a lot of different garages into a small city. Down near Old Town and the ferry terminal, older homes sit on steep streets with tuck-under garages and daylight basements. Up on the plateau in Harbour Pointe, newer neighborhoods have two and three-car garages on wider lots. Along the Mukilteo Speedway and out toward Paine Field, you will find everything in between, plus workshops and small businesses.
Hillside homes often have more than one slab worth coating. If your lower level opens onto concrete, our guide to basement floor coatings and moisture is a good read.
We also coat floors in the towns around you, including Everett next door, Edmonds down the shoreline, Lynnwood and Mill Creek inland and Marysville to the north. Permits and local services run through the City of Mukilteo, and Mukilteo on Wikipedia covers the lighthouse and ferry history.
Roll a kit or a low bid over an untested hillside slab and the clock starts. Blisters show up where the moisture is highest, often right by the door. Then everything comes out of the garage, someone grinds off the failed layer and you pay for a second floor. If the installer has moved on, the warranty went with them.
Now picture the other version. A bright, glossy floor under the house that sweeps clean in two minutes. A garage that doubles as a den or a home gym, the way one Marysville owner turned a bay into a real room. Our post on workshop, gym and den garage ideas has more. It still looks right decades from now, and you only choose it once.
Don't see yours? Call 425-226-6085 and an owner will answer it.
Yes. We install epoxy poly garage floors across Mukilteo using Certified Penntek polyurea instead of epoxy. It looks like a premium flake floor and offers up to 5x the lifespan of typical epoxy. See all our services or book a free in-home quote.
We do. The same Penntek system that protects garages works on outdoor concrete around Mukilteo, with a slip-resistant finish and FadeLock UV stability. See patio and walkway projects.
Yes. We coat shops, showrooms, clinics and service bays in and around Mukilteo. See our commercial projects.
Call 425-226-6085 or request a free in-home quote. An owner visits, tests your slab and brings color samples. We don't quote over the phone because every slab is different.
We built this page so people in Mukilteo searching for epoxy garage floors and concrete coatings would find us. Thanks for reading this far. We only have one finished floor inside the city so far, so we showed you that one in full and then the closest real floors around it.
If your garage sits on a damp hillside slab, we would like to read it. Book a free in-home quote or call 425-226-6085.
Book a free in-home quote and we will test your concrete in more than one spot and bring real samples. Call 425-226-6085.