Don't get stuck redoing your floor every few years. We'll test your Edmonds slab, prep it right and install a Certified Penntek polyurea floor that bonds with your concrete, so you can stop worrying about the garage and start enjoying it.
Cascade Concrete Coatings, a Certified Penntek Dealer based in Woodinville, installs epoxy-style garage floor coatings in Edmonds. We install Certified Penntek polyurea instead of epoxy, chemically bonded to diamond-ground concrete at over 1,300 PSI and finished with a UV-stable polyaspartic topcoat. Seven Edmonds garages so far, most finished in one day after a free in-home quote with moisture and hardness testing. Penntek backs every floor with a limited lifetime warranty.
Homes here tend to be well kept. You see it in the gardens, the decks facing the Olympics and the care people put into older houses on the hill. Then you open the garage, and the floor tells a different story.
Inside, we keep meeting the same few problems. A crack running toward the door. A web of fine map cracking across an older slab. Oil where two cars have parked for years. Pine needles and grit that never fully sweep out. And sometimes an old coating that has gone yellow and is coming off in sheets.
That last one is the warning. A typical epoxy garage floor gets a light etch, a thin coat and no moisture test. It is rigid, so cracks come through. It is not UV stable, so it ambers where the afternoon light hits. In a few years you are back where you started, with a mess to grind off.
Every Edmonds job starts with a moisture and hardness test, then industrial diamond grinding, crack repair with Penntek Mender and a pure polyurea basecoat with a FadeLock UV topcoat. That's how we deliver up to 5x the lifespan of typical epoxy, a 30 to 40 year floor, with a limited lifetime warranty backed by Penntek.
Drag the handle to compare. Every pair is a real floor our team ground, repaired and coated.
The coating is only half of it. Watch the same slab go through what a Edmonds garage puts it through, once with typical epoxy or cheap poly and once the way we install Penntek.
Your slab’s age, composition and moisture all matter. We test it first, then choose the Penntek system that fits, adding a moisture barrier when the readings call for it.
Moisture & hardness testedSide-by-side tests on the same slab, in the same conditions. Typical epoxy and cheap poly on one side, certified Penntek on the other.
A floor that fails doesn't just look bad. It means emptying the garage, grinding off the old coating and paying all over again.
For a lot of Edmonds families it's the gym, the workshop, the mudroom and the first thing you see when you get home. You've put real money into it. You deserve a floor you never have to think about again, installed by people who treat your home like their own.
Nicole and Sheldon, owners of Cascade Concrete CoatingsHere's what a Certified Penntek floor from our team gives you, long after install day.
Every certified Penntek floor is built in four layers, each doing its own job. Watch it go down layer by layer, then tap a layer to see what it does for your floor.
When moisture readings call for it, we add a two-layer moisture barrier system before the basecoat.
We know you typed epoxy. Most people do, and many homeowners here call our work an epoxy poly garage floor because the steps look alike. Under the surface it is Certified Penntek polyurea, and the difference is a four-part combination.
Two details matter in a town that faces west over the water. FadeLock™ UV stability passed a 16-hour QUV test, so the floor near an open door does not yellow the way the failed coating here did. And the polyaspartic topcoat resists hot tire pickup, oil, salt and chemicals. Read about UV damage on garage floors, then watch the tests on our Penntek demo.
Anyone can buy a kit and call themselves a garage floor company. Penntek doesn't sell to just anyone. Our team was vetted, trained hands-on through Penntek Academy and is backed by Penntek's full-time technical support team from prep to finish. That's the Penntek Standard, on every floor we install.

Garages are most of what we do in Edmonds, but the same Penntek system protects patios, pool decks, basements and commercial floors.
In one garage here, plastic sheeting went up like curtains and the shelves stayed put. We plan around your space. The full installation process shows how.
Cascade Concrete Coatings is a Certified Penntek Dealer based in Woodinville, a straight shot west on SR 522 and SR 104 to your side of south Snohomish County. Your town has become one of our regular stops.
Every quote starts on your garage floor. We scratch test the concrete for hardness and read moisture in at least two places. Across the seven garages we have coated in town, those readings have run from 3.2% to 4.9%. That is a healthy range, but we still check every slab, because the one that surprises you is the one you skipped.
We also look at what else is in the room. Furnaces on stands, water heaters, center posts, stem walls and full storage walls are all normal here, and each one changes how the crew plans the day.
You're probably a great fit if any of these sound familiar.
Two colors lead in town, each chosen twice. Mount Everest brightens long single bays and garages packed with storage. Tidal Wave handles busy two-car garages with posts and oil history. Smoke, Slate Stone and Domino each have a garage here too. See the whole range on our styles and colors page.
This is one of the places where we have done the most work, so you can see a real range here. A huge three-bay garage done in January. A failed coating ground off and replaced. A garage so full we coated it with the storage still on the walls. A map-cracked slab finished in September 2026.
One more worth a look: a garage that doubles as the mechanical room, coated wall to wall and under the water heater stand in Domino flake in August 2025, with readings of 4.0% and 3.2%. More are in our complete portfolio.
An owner comes out, tests your slab, brings real color samples and writes a clear quote. No pressure, just a plan for a floor you'll only buy once.
We work all over Edmonds. Downtown in the Bowl near the ferry terminal, Brackett's Landing and the Edmonds Marsh. Up the hill in Seaview and Westgate. North in Meadowdale and Perrinville. East toward Five Corners, Firdale Village, Esperance and the Highway 99 corridor.
The housing mixes mid-century ramblers, daylight-basement homes on view lots and newer builds. Many garages are tucked into slopes that step down toward Puget Sound, and many hold more than cars: furnaces, water heaters, workbenches and years of family gear. We have coated around all of it.
Edmonds sits in Snohomish County, and the City of Edmonds is the place to check permits if your floor is part of a bigger remodel. For local history, see Edmonds on Wikipedia. We also serve Lynnwood, Shoreline, Mill Creek and Mukilteo.
One homeowner in town had. Somebody coated the garage and side room before us, and by the time we saw it, a yellowed film was lifting into a patchwork of bare concrete and loose flakes. Paying for a floor is one cost. Paying to remove it, then paying again, is the cost nobody plans for.
Done right, the story ends differently. The slab is tested, ground and repaired, and the new concrete coating bonds chemically. Grit and needles sweep off. The color holds by the door. Our post on how long a Penntek floor lasts covers the long view, and the year-round care guide shows how little upkeep it takes.
Don't see yours? Call 425-226-6085 and an owner will answer it.
Yes. We install epoxy poly garage floors across Edmonds using Certified Penntek polyurea instead of epoxy. It looks like a premium flake floor and offers up to 5x the lifespan of typical epoxy. See all our services or book a free in-home quote.
We do. The same Penntek system that protects garages works on outdoor concrete around Edmonds, with a slip-resistant finish and FadeLock UV stability. See patio and walkway projects.
Yes. We coat shops, showrooms, clinics and service bays in and around Edmonds. See our commercial projects.
Call 425-226-6085 or request a free in-home quote. An owner visits, tests your slab and brings color samples. We don't quote over the phone because every slab is different.
We wrote this page so people in Edmonds searching for epoxy garage floors and concrete coatings would find us. We could have kept it short. Instead we put in the real readings, square footage and months from seven garages in your town, because that is what we would want to read.
If yours is next, call 425-226-6085. We will bring the meter.
Book a free in-home quote. We will test your slab, measure the room and show you colors in your own light. Call 425-226-6085.